Selecting Clips - Panasonic AJ-HPD2500 Operating Instructions Manual

Select clips for processing in the thumbnail screen as
described below.
1
2
1
Use the cursor buttons to place the yellow frame
(cursor) on the desired clip.
◆ NOTE:
• Hold down the SHIFT button and press the REW/FF button or the
cursor buttons (4 / 5 / b / a) to move the cursor to the first or
last clip.
2
Press the SET button.
A blue frame appears on the clip selected with the cursor
to indicate that it is selected.
◆ NOTE:
• Repeat steps 1 and 2 to select multiple clips.
• After selecting a clip, move the cursor to another clip, hold down
the SHIFT button and press the SET button to select another
clip. This method allows you to select the two clips as well as all
the clips between them.
• Selecting a clip updates the number of selected clips shown in
the lower right corner of the screen.
58
Clip Management: Selecting Clips

Selecting Clips

Canceling a selection
1
Place the cursor on a selected clip and press the SET
button again.
This cancels the selection.
◆ NOTE:
• Hold down the SHIFT button and press the EXIT button to cancel
all the made selections.