About The Clip Select Function; Clip Select Setting; Canceling Clip Select - Panasonic AJ-HPD2500 Operating Instructions Manual

Clip Select Function

About the Clip Select Function

Use the clip select function to play back only one clip.

Clip Select Setting

3
1
Open the thumbnail screen.
2
Use the cursor to select the clip to be played back.
3
Press the CLIP SELECT button.
The CLIP SELECT button lights and the first frame or
*1
thumbnail position
select mode does not differ from normal playback, but
enables playback with fixed delay. During playback the
CLIP SELECT button flashes but the unit stays in clip
select status.
Pressing the CLIP SELECT button when it is flashing in
playback stop mode or playback pause mode changes
flashing to steady light. When the CLIP SELECT button is
lit, the unit is in PB mode regardless of PB/EE mode
setting.
Changing the initial position will cause the CLIP SELECT
button to flash and cancel fixed delay. Press the CLIP
SELECT button to turn it on, and fixed delay resumes.
*1:This depends on the value set in setup menu No. 165
(CLIPSEL MODE) (page 179).
148
Clip Select Function: About the Clip Select Function
1
2
of the clip appears. Playback in clip
◆ NOTE:
• The clip select function is available when setup menu No.25
(SYSTEM FREQ) is set to 50 or 59.94.
• The CLIP SELECT function cannot be applied to clips in a hard disk.
• The clip select function does not work in the AVCHD mode.
• The CLIP SELECT function is not available on the playlist player
thumbnail screen.
• If playback is started immediately after a USB, eSATA or LAN cable
was disconnected and re-connected in the fixed delay mode, video
dropouts may occur, or the fixed delay mode may be canceled.
• In clip select status, recording, play list, thumbnail screen, switching
devices and other functions may not be available.
• When the CLIP SELECT button is on, the time that elapses from
pressing the PLAY button until start of playback is the fixed delay.
(Fixed delay)

Canceling Clip Select

3
1
Press the SHIFT and CLIP SELECT buttons
simultaneously.
The CLIP SELECT button goes off.
◆ NOTE:
• The clip select status can be canceled only in playback stop mode.
• When playback is stopped by pressing the STOP button during the
CLIP SELECT mode, or if the CLIP SELECT mode is canceled, the
thumbnail screen does not return.