Setting Up For Playback - Panasonic AJ-HPD2500 Operating Instructions Manual

USER CLIP NAME to be recorded
• When clip metadata is loaded
TYPE1: Loaded data
TYPE2: Loaded data + counter value
• When clip metadata is not loaded or when loaded clip
metadata is not to be recorded
TYPE1: A 5-digit serial number assigned in
shooting order
TYPE2: A 5-digit serial number assigned in
shooting order
*1:The counter value is indicated as a four-digit number.
The counter value is incremented by 1 each time a clip is
played back when clip metadata is loaded and recording
method TYPE2 is set for recording metadata.
Use the following procedure to reset the counter value.
Press the MENU button, choose [META DATA] – [CLIP
COUNT RESET] – [YES] and press the SET button to reset
the counter value to 1.
Adding shot marks to clips
Adding shot marks (M) makes it easier to find desired clip.
1
Press the cursor buttons to move the yellow frame to
the clip to which you will add a shot mark.
2
Press the MARKER (SHIFT + TEXT MEMO) button.
To cancel a shot mark, repeat the above operation.

Setting up for Playback

Set playback format and playback type.
Setting playback format (PB FORMAT)
Use the steps below to set playback format.
➝Refer to "Menu Operations" (page 38).
1
Press the MENU button.
2
Select [PLAY SETUP] and press the SET button.
3
Select [PB FORMAT] and press the SET button.
4
Press the up and down (4/5) cursor buttons to select
playback format and press the SET button.
*1
• Available formats
(When SYSTEM FREQ is set to 59.94 Hz)
1080/60i(30P), 1080/24P, 720/60P(30P), 720/24P
(When SYSTEM FREQ is set to 50 Hz)
1080/50i(25P), 720/50P(25P)
5
Press the MENU button to return to the thumbnail
screen.
Clips with black numbers can be played while clips with
red numbers cannot be played back.
Switching to the normal mode will replace a set playback
format with a playback format set by the setup menu
No. 020 (SYS FORMAT).
Repeat playback (REPEAT PLAY)
When setup menu No. 160 (REPEAT PLAY) is set to ON, all
playable clips will be played continuously.
➝Refer to "Setup" (page 164).
Resume playback (RESUME PLAY)
Resume play starts playback from where it was last
interrupted.
1
Press the MENU button.
2
Select [PLAY SETUP] and press the SET button.
3
Select [RESUME PLAY] and press the SET button.
4
Select [ON] and press the SET button.
5
Press the MENU button to return to the thumbnail
screen.
6
Select clip to play back.
When playback is interrupted, the resume play indicator
appears on the clip thumbnail and playback continues
from this point the next time playback is started.
AVCHD Recording and Playback: Using an Optional AVCHD Board
159