Creative SB0350 Programming Manual page 98

36h
Output
36h
Remarks
For time stamping mode, in-bound MIDI data is tagged with a time stamp by the
DSP. The time stamp is a 3-byte quantity in units of milliseconds.
The order of time stamped in-bound MIDI data is:
Refer to command 34h on the characteristics of MIDI UART mode and on how to
terminate it.
See Also
command 37h, Interrupt mode MIDI I/O with time stamping
1.xx
Available
37h
Output
37h
Remarks
After sending this command, the DSP will generate an interrupt to signal the
application when there is any in-bound MIDI data. In-bound MIDI data is time
stamped by the DSP.
Refer to command 34h on the characteristics of MIDI UART mode and on how to
terminate it.
Refer to command 36h on MIDI time stamping mode.
See Also
command 36h, UART polling mode MIDI I/O with time stamping
Available 1.xx
UART polling mode MIDI I/O with time stamping
nTime.LowByte, nTime.MidByte, nTime.HighByte, bMidiData
2.00 2.01+ 3.xx
UART interrupt mode MIDI I/O with time stamping
2.00 2.01+ 3.xx
DSP Commands
4.xx
4.xx
6-13