Creative SB0350 Programming Manual page 101

6-16 DSP Commands
48h
Output
48h, wBlockSize.LowByte, wBlockSize.HighByte
Remarks
The DSP will generate an interrupt after transferring the block of data.
wBlockSize is a word giving the number of bytes to transfer less 1.
This command is used with high-speed mode and auto-init DMA mode.
See Also Commands that initiate high-speed mode digitized sound I/O
Commands that initiate auto-init DMA mode digitized sound I/O
1.xx
Available
74h
Output
74h, wLength.LowByte, wLength.HighByte
Remarks Refer to command 16h.
See Also
command 75h, Creative 8-bit to 4-bit ADPCM single-cycle DMA mode digitized
sound output with reference byte
Available 1.xx
Set DSP block transfer size
2.00 2.01+ 3.xx
Creative 8-bit to 4-bit ADPCM single-cycle DMA
mode digitized sound output
2.00 2.01+ 3.xx
4.xx
4.xx