Creative SB0350 Programming Manual page 93

6-8 DSP Commands
1Ch
Output
1Ch
Remarks
Output unsigned digitized sound data using auto-init DMA mode. The DSP will
generate an interrupt to signal the application after transferring every Block of data
of size set by command 48h.
There are 2 ways to terminate auto-init DMA mode I/O:
1. Program single-cycle DMA mode digitized sound I/O.
2. Send out the exit auto-init DMA mode digitized sound I/O command.
See Also
command 2Ch, 8-bit auto-init DMA mode digitized sound input
command D0h, Pause 8-bit DMA mode digitized sound I/O
command D4h, Continue 8-bit DMA mode digitized sound I/O
command DAh, Exit 8-bit auto-init DMA mode digitized sound I/O
1.xx
Available
8-bit auto-init DMA mode digitized sound output
The DSP will, at the end of the current block transfer, exit auto-init mode and
process the new DMA mode I/O command.
The DSP will, at the end of the current block transfer, exit auto-init mode and
terminate digitized sound I/O.
2.00 2.01+ 3.xx 4.xx