Creative SB0350 Programming Manual page 105

6-20 DSP Commands
90h
Output
90h
Remarks The DSP will generate an interrupt to signal the application after transferring every
Block Size of data set by command 48h.
In high-speed mode, the DSP will not accept any other commands. To terminate
high-speed mode, send a DSP reset command.
The DSP reset command behaves differently while the DSP is in high-speed mode. It
terminates high-speed mode and restores all DSP parameters to the states prior to
entering the high-speed mode.
See Also
command 91h, 8-bit high-speed single-cycle DMA mode digitized sound output
command 98h, 8-bit high-speed auto-init DMA mode digitized sound input
Available 1.xx
91h
Output
91h
Remarks
After transferring a block of data of size set by command 48h, the DSP will generate
an interrupt to signal the application and exit the high-speed mode.
See Also command 90h, 8-bit high-speed auto-init DMA mode digitized sound output
command 99h, 8-bit high-speed single-cycle DMA mode digitized sound input
1.xx
Available
8-bit high-speed auto-init DMA mode digitized
sound output
2.00 2.01+ 3.xx
8-bit high-speed single-cycle DMA mode digitized
sound input
2.00 2.01+ 3.xx
4.xx
4.xx