Product Hardware Features - TRENDnet TPE-1020WS User Manual

TRENDnet User's Guide

Product Hardware Features

Rear View
• AC Power Connector – Connect the AC power cord to the connector and the
other side into a power outlet. (Input: 100~240VAC, 50/60Hz)
Front View
Reset
Diagnostic
Button
LEDs
• Reset Button – Press and hold this button for 10 seconds and release to
reset the switch to factory defaults.
•
PoE+ Gigabit Ports (1-8) – Connect PoE and non-PoE network devices.
• Gigabit Ports (9R-10R) – Connect non-PoE devices or uplinks. Disabled
when SFP slots (9-10) are in use.
• SFP slots (9-10) – Supports optional 1000BASE-SX/LX mini-GBIC modules.
© Copyright 2013 TRENDnet. All Rights Reserved.
AC Power Connector
Gigabit
PoE+ Gigabit
SFP
Ports
Ports
Slots
• Diagnostic LED Indicators
• Power LED
: When the Power LED lights on, the device is receiving
On
power.
: When the Power turns off or the power cord is not
Off
connected
•
PoE MAX (Power over Ethernet Max.)
On (Red) : When reaching near the max PoE power budget provided
68W or above, the LED will turn on and the system will
not provide power additional PD (PoE client devices)
after max PoE budget is reached..
Off : When the PoE power provided is below the 68W PoE
power budget.
• PoE+ Gigabit Ports (1-8)
• L/A: Link/Activity
On : When the Link/ACT LED lights on, the respective port is
successfully connected to an Ethernet network.
Blinking : When the Link/ACT LED is blinking, the port is
transmitting or receiving data on the Ethernet network.
Off : No link.
• SPD: Speed
Green : When the Green LED lights on, the respective port is
on connected to a 1000Mbps Gigabit Ethernet network.
Amber : When the respective port is connected to a 10Mbps or
on 100Mbps Ethernet network.
• PoE (Power over Ethernet)
Green : When the PoE powered device (PD) is connected and the
port supplies power normally.
TPE-1020WS
6