Add Radius Servers (Radius Authentication Method) - TRENDnet TPE-1020WS User Manual

TRENDnet User's Guide

Add RADIUS Servers (RADIUS Authentication Method)

Security > RADIUS
1. Log into your switch management page (see
on page 11).
2. Click on Security and click on RADIUS.
3. Review the settings.
•
Server Priority – Enter the RADIUS Server priority (Highest: 1, Lowest: 5).
•
Server IP Address –Select IPv4 or IPv6 and set the RADIUS server IP address
and enter the IP address of the RADIUS server you would like to add.
• Server Port (1 - 65535) –Set the RADIUS authentic server(s) UDP port. The
default port is 1812.
• Accounting Port (1 - 65535) –Set the RADIUS account server(s) UDP port. The
default port is 1813.
• Shared Secret – Enter the default authentication and encryption key for
RADIUS communication between the device and the RADIUS server.
Click Add to add the entry to the table.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-1020WS
71