Power connector cable
NOTE:
The power connector cable is included in the Cable Kit, spare part number 595787-001.
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Remove the power connector cable:
1.
Position the computer right-side up, with the front toward you.
2.
Lift the power connector (1) up from the clips (2) in the rear of the base enclosure.
102 Chapter 4 Removal and replacement procedures
Battery on page
Hard drive (see
Hard drive on page
Optical drive (see
Optical drive on page
Keyboard (see
Keyboard on page
Switch cover (see
Switch cover on page
Display assembly (see
Top cover (see
Top cover on page
Fan (see
Fan on page
73)
Heat sink (see
Heat sink on page
Modem module (see
Modem module on page
System board (see
System board on page
47).
54)
49)
65)
71)
Display assembly on page
87)
75)
96)
81)
91)