Rj-11 Connector Cable - HP XT905UT Maintenance And Service Manual

Reverse the preceding procedure to install the system board.

RJ-11 connector cable

NOTE: The RJ-11 connector cable is included in the Cable Kit, spare part number 595787-001.
Before removing the RJ-11 connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Remove the RJ-11 connector cable:
1. Position the computer right-side up, with the front toward you.
2. Remove the RJ-11 connector (1) from the clip built into the base enclosure.
98 Chapter 4 Removal and replacement procedures
Battery on page
Hard drive (see Hard drive on page
Optical drive (see Optical drive on page
Keyboard (see Keyboard on page
Switch cover (see Switch cover on page
Display assembly (see
Top cover (see Top cover on page
Fan (see Fan on page 73)
Heat sink (see Heat sink on page
Modem module (see Modem module on page
System board (see System board on page
47).
54)
49)
65)
71)
Display assembly on page
87)
75)
96)
81)
91)