RJ-11 connector cable
NOTE:
The RJ-11 connector cable is included in the Cable Kit, spare part number 641830-001.
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Remove the bottom door (see
b.
Hard drive (see
c.
Optical drive (see
d.
WLAN module (see
e.
WWAN module (see
f.
Modem module (see
g.
Fan (see
h.
Heat sink (see
i.
Keyboard (see
j.
Bottom cover (see
Remove the RJ-11 connector cable:
1.
Position the bottom cover with the front toward you.
2.
Remove the RJ-11 connector (1) from the clip built into the base enclosure.
108 Chapter 4 Removal and replacement procedures
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
WLAN module on page
WWAN module on page
Modem module on page
Fan on page
90)
Heat sink on page
Keyboard on page
Bottom cover on page
63).
70).
76)
72)
83)
81)
89)
91)
96)
98)