RJ-11 connector cable
NOTE:
The RJ-11 connector cable is included in the Cables Kit, spare part number 452198-001.
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
Display assembly (see
f.
Top cover (see
g.
Fan (see
h.
Heat sink (see
i.
Modem module (see
j.
System board (see
Remove the RJ-11 connector cable:
1.
Position the computer right-side up, with the front toward you.
2.
Remove the RJ-11 connector (1) from the clip built into the base enclosure.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Fan on page
79)
Heat sink on page
Modem module on page
System board on page
44).
50)
46)
60)
65)
68)
74)
81)
63)
88)
Component replacement procedures
91