Rj-11 Connector Cable - HP 8510w Maintenance And Service Manual

Mobile workstation and notebook pc
Hide thumbs Also See for 8510w:
Table of Contents

Advertisement

7.
Remove the system board (3) from the system board frame by sliding it forward.
Reverse the preceding procedure to install the system board.

RJ-11 connector cable

NOTE:
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
b.
c.
d.
e.
f.
g.
h.
i.
94
Chapter 4 Removal and replacement procedures
The RJ-11 connector cable is included in the Cables Kit, spare part number 452198-001.
Battery on page
Hard drive (see
Hard drive on page
Optical drive (see
Optical drive on page
Keyboard (see
Keyboard on page
Fan (see
Fan on page
63)
Heat sink (see
Heat sink on page
Switch cover (see
Switch cover on page
TouchPad (see
TouchPad on page
Display assembly (see
Display assembly on page
Top cover (see
Top cover on page
47).
51)
54)
58)
64)
75)
70)
79)
84)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

8510pCompaq 8510pCompaq 8510w

Table of Contents