Table of Contents
Advertisement
Reverse this procedure to install the TouchPad button board and cable.
Optical drive connector cable
NOTE:
The optical drive connector cable is included in the Cable Kit, spare part number
652696-001.
Before removing the optical drive connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b.
Optical drive (see
c.
Hard drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the optical drive connector cable:
1.
Disconnect the optical drive connector cable (1) from the system board.
2.
Remove the Phillips PM2.0×3.0 screw (2) that secures the optical drive connector and bracket to
the base enclosure.
70
Chapter 4 Removal and replacement procedures
Battery on page
41), and then remove the following components:
Optical drive on page
Hard drive on page
54)
Keyboard on page
57)
Top cover on page
60)
WLAN module on page
52)
44)
Advertisement
Table of Contents
