Table of Contents
Advertisement
5.
If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Remove the two screw covers (1) and the two Phillips PM2.5×4.5 screws (2) that secure the
display bezel to the display assembly. The screw covers are available in the Display Rubber
Kit, spare part number 650481-001.
b.
Flex the inside edges of the top edge (1), the left and right sides (2), and
the bottom edge (3) of the display bezel until the bezel disengages from
the display enclosure.
c.
Remove the display bezel (4). The display bezel is available using spare part number
650454-001.
6.
If it is necessary to replace the hinge covers:
a.
Remove the two Phillips PM2.5×4.0 (1) screws that secure the hinge covers to
the display enclosure.
92
Chapter 4 Removal and replacement procedures
Advertisement
Table of Contents
