6.
Remove the TouchPad button board (5).
Reverse this procedure to install the TouchPad button board.
Optical drive connector cable
NOTE:
The optical drive connector cable is included with the Optical Drive, spare part number
734415-001.
Before removing the optical drive connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Service door (see
c.
WLAN module (see
d.
Memory module (see
78
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
49), and then remove the following components:
Optical drive on page
Service door on page
50)
WLAN module on page
Memory module on page
55)
53)
51)