Optical Drive Connector Cable - HP ProBook 470 G4 Maintenance And Service Manual

Optical drive connector cable

Description
Cable Kit
The optical drive connector cable is included in the Cable Kit.
Before removing the optical drive connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Service door (see
b. Optical drive
c. Hard drive
d. Keyboard (see
e. Top cover (see
f. Battery (see
Remove the optical drive connector cable:
1. Position the computer upright on a flat surface.
2. Disconnect the optical drive connector cable from the system board (1).
3. Remove the cable from the clips built into the computer (2).
68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service door on page
(Optical drive on page 32)
(Hard drive on page 34)
Keyboard on page 41)
Top cover on page 48)
Battery on page 62)
31).
Spare part number
906000-001