Logs Setup; Alarms Setup - Navman Tracker 5430 Installation And Operation Manual

13-6 Logs setup

The values can be changed independently of
each other. These log values are saved when the
unit is turned off.
The TRACKER has two distance logs.
Trip distance:
The distance travelled since log was reset.
Total distance:
The distance travelled since total log was reset.
Reset trip dist
This resets the trip distance to zero.
Reset total dist
This option resets the total distance to zero.

13-7 Alarms setup

For alarm operation, see section 2-5. To turn off
an alarm which is sounding, press ESC.
Arrival radius alarm
When the arrival radius alarm is enabled, an
alarm will sound:
a When the boat is going to a point and the
boat comes within the arrival radius of the
destination.
b Or when the boat is navigating a route and
the boat comes within the arrival radius of a
waypoint in the route.
To enable the alarm, enter an arrival radius
(up to 9.99 distance units).
To disable the alarm, set the arrival radius
to Off (0).
Anchor alarm
When the anchor alarm is enabled, an alarm will
sound when the boat moves by more than the
anchor alarm distance.
To enable the alarm, enter an anchor alarm
distance (up to 9.99 distance units). The
TRACKER saves the current boat position.
To disable the alarm, set the anchor alarm
to Off (0).
The minimum usable setting of the alarm
is determined by the accuracy of the global
positioning system, typically within 10 m (33 ft).
Warning: Do not rely on the anchor alarm
as the only anchor watch.
32
XTE alarm
When the XTE alarm is enabled, an alarm will
sound when the boat is navigating to a point
and the distance from the boat to the plotted
course (XTE) is more than CDI (Course Deviation
Indicator) scale (see appendix C, CDI).
To enable the alarm, set the XTE alarm to On.
To disable the alarm, set the XTE alarm to Off.
Danger alarm
When the danger alarm is enabled, an alarm will
sound when the boat comes within this distance
of a danger waypoint.
To enable the alarm, enter an danger alarm
distance (up to 9.99 distance units).
To disable the alarm, set the danger alarm to
Off (0).
Low fuel alarm
When the low fuel alarm is enabled, an alarm will
sound when the fuel remaining in the tank is less
than the low fuel value.
To enable the alarm, enter a low fuel value.
To disable the alarm, set the low fuel value
to Off.
DGPS alarm
When the DGPS alarm is enabled, an alarm will
sound when the TRACKER can not receive the
DGPS signal (beacon, WAAS or EGNOS)
NAVMAN
TRACKER 5430/5430i Installation and Operation Manual