Converting To Another Gas Type - Frymaster MASTERJET J1C Series Installation, Operating, Service And Parts Manual

J1C, J1X, & J2X MASTER JET SERIES GAS FRYERS
2.5

Converting to Another Gas Type

Your fryer is configured at the factory for either natural gas or Propane (LP) gas.
If you desire to switch from one type of gas to another, a gas conversion kit must be installed by
an Authorized Service Agency technician.
This appliance was configured at the factory for a specific type of gas. Converting
from one type of gas to another requires the installation of specific gas-conversion
Switching to a different type of gas without installing the proper conversion kit may
result in fire! NEVER ATTACH THIS APPLIANCE TO A GAS SUPPLY FOR WHICH IT
Conversion of this appliance from one type of gas to another should only be
performed by qualified, licensed, and authorized installation or service personnel, as
For fryers at elevations at or above 5,000 feet (1524 meters), call Frymaster Service (1-
800-551-8633) to determine the components appropriate for your configuration and
altitude. Contact your local ASA to order the components and arrange for installation. For
fryers below 5000 feet (1524 meters), see the kits listed below for conversion.
applicable to non-CE units only.
Natural to Propane
Regulator Conversion Kit: P/N 807-1846
Pilot, regulator conversion kit, and orifices kit: P/N 826-1141 (J1C)
Propane to Natural
Regulator Conversion Kit: P/N 807-1849
Pilot, regulator conversion kit, and orifices kit: P/N 826-1142 (J1C)
CHAPTER 2: INSTALLATION INSTRUCTIONS
components.
IS NOT CONFIGURED!
defined in Section 1.6 of this manual.
Gas Conversion Instructions
(for J1C Fryers only)
DANGER
DANGER
2-7
Kits