Advertisement
J1C, J1X, & J2X MASTER JET SERIES GAS FRYERS
1.1 Parts Ordering and Service Information
In order to assist you as quickly as possible, the Frymaster Authorized Service Agency (ASA) or
Service Department representative requires certain information about your equipment. Most of this
information is printed on a data plate affixed to the inside of the fryer door.
Parts orders must be placed directly with your local ASA or distributor. Included with fryers when
shipped from the factory is a list of Frymaster ASAs. If you do not have access to this list, contact
the Frymaster Technical Service Department at 1-800-551-8633 or 1-318-865-1711.
When ordering parts, the following information is required:
Service information may be obtained by contacting your local ASA. Information may also be
obtained by calling the Frymaster Technical Service Department at 1-800-551-8633 or 1-318-865-
1711.
When requesting service, please have the following information ready:
In addition to the model number, serial number, and type of gas, please be prepared to describe the
nature of the problem and have ready any other information that you think may be helpful in solving
your problem.
1.2 Safety Information
Before attempting to operate your unit, read the instructions in this manual thoroughly.
Your fryer is equipped with a high limit thermostat, which detects high temperatures and shuts off
gas to the burner assembly should the controlling thermostat fail.
Additionally, J2X fryers are equipped with a safety switch built into the drain valve to prevent
burner ignition while the drain valve is open.
Throughout this manual, you will find notations enclosed in double-bordered boxes similar to the
ones below.
CHAPTER 1: INTRODUCTION
Model Number:
Serial Number:
Type of Gas or Voltage:
Item Part Number:
Quantity Needed:
Model Number:
Serial Number:
Type of Gas:
1-1
Advertisement
Troubleshooting
