Replacing The Frypot - Frymaster MASTERJET J1C Series Installation, Operating, Service And Parts Manual

J1C, J1X, & J2X MASTER JET SERIES GAS FRYERS
7.9 Alignment & Adjustment of Metal Burner Deflector
1. Proper alignment of all burner targets should be 3/4 inch between the top edge of the targets
and the wall of the frypot.
2. To adjust targets, bend the deflector brackets away or toward the frypot to obtain the 3/4 inch
measurement. See Figure 7.
7.10

Replacing the Frypot

1. Drain all shortening from the frypot.
2. Disconnect the fryer from the gas supply.
3. If equipped, remove the frypot covers and basket
hangers.
4. Remove the screws from the cowl and lift up and
off the fryer. See Figure 8 and Figure 1, Item 7.
5. Remove the screws from the sides and back of
the flue cap and remove the flue cap. See Figure
9.
6. Lift frypot complete with burner, gas valve, flue,
drain valve, and combustion chamber from the
fryer cabinet. After lifting frypot partially out of
the cabinet, tilt the front of the pot up slightly to
clear the drain valve.
7. Remove the burner assembly, flue, drain valve,
and combustion chamber from the old frypot and
install on the new frypot.
8. Reverse the previous procedures to install the
new frypot assembly.
CHAPTER 7: SERVICE PROCEDURES
Figure 7
7-6
Figure 8
Figure 9