Admin Menu; Network Setup - Fuji Xerox DocuPrint CP205 User Manual

Admin Menu

Use the Admin Menu menu to configure a variety of printer features.
NOTE:
• A password is required to enter the operator panel menus when Panel Lock Set is set to Enable. In this
case, enter the password you specified, and press the

Network Setup

Use the Network Setup menu to change the printer settings affecting jobs sent to the printer
through the wired or wireless network.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the printer is turned off and then on.
Values:
Auto*
10Base Half
10Base Full
100Base Half
100Base Full
NOTE:
• This item is displayed only when the printer is connected with a wired network.
• Wireless Status (DocuPrint CP205 w Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
Good
Acceptable
Low
No Reception
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
167 Using the Operator Panel Menus
button.
Detects the Ethernet settings automatically.
Uses 10base-T half-duplex.
Uses 10base-T full-duplex.
Uses 100base-TX half-duplex.
Uses 100base-TX full-duplex.
Indicates good signal strength.
Indicates marginal signal strength.
Indicates insufficient signal strength.
Indicates that no signal is received.