Port Status; Power Saver Timer - Fuji Xerox DocuPrint CM305 df User Manual

All-in-one printers
Hide thumbs Also See for DocuPrint CM305 df:
Table of Contents

Advertisement

• Port Status

Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned
off and then on again.
Values:
Disable
*
Enable
• Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto
Standard
BCP
TBCP*
Binary
System Settings
Use System Settings to configure a variety of printer features.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.

• Power Saver Timer

Purpose:
To specify the time for transition to power saver mode.
Values:
Low Power
Timer
Sleep Timer
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer
ready to operate with minimum warm-up time. Select a value between 5 and 30 minutes for power
saver mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives
data from the computer or remote fax machine. You can also change the status of the printer to the
standby mode by pressing the Energy Saver button on the operator panel.
325
Using the Operator Panel Menus and Keypad
Disables the USB interface.
Enables the USB interface.
Sets the PostScript communications protocol automatically.
Sets the PostScript communications protocol to Standard.
Sets the PostScript communications protocol to BCP.
Sets the PostScript communications protocol to TBCP.
Sets the PostScript communications protocol to Binary.
*
3min
Specifies the time taken by the printer to enter Low Power mode after
it finishes a job.
3–60 min.
*
6min
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–6 min.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents