Ip Filter - Fuji Xerox DocuPrint CM305 df User Manual

SNMP
StatusMessenger
InternetServices
Bonjour(mDNS)
Telnet
Update Addr Book
HTTP-SSL/TLS

• IP Filter

NOTE:
• IP Filter feature is available only when Protocol is set to LPD or Port9100.
Purpose:
To block data received from certain IP addresses through the wired network. You can set up to five IP
addresses. The change becomes effective after the printer is turned off and then on again.
Values:
No. n / Address (n is 1–5.)
No. n / Mask (n is 1–5.)
No. n / Mode (n is
1–5.)
• IEEE 802.1x
NOTE:
• IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only
when the IEEE 802.1 authentication is enabled.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off
and then on again.
Value:
Disable
Disable Disables the Simple Network Management Protocol (SNMP)
UDP port.
*
Enable Enables the SNMP UDP port.
Disable Disables the E-Mail Alert feature.
*
Enable Enables the E-Mail Alert feature.
Disable Disables an access to CentreWare Internet Services
embedded in the printer.
*
Enable Enables an access to CentreWare Internet Services
embedded in the printer.
Disable Disables Bonjour (mDNS).
*
Enable Enables Bonjour (mDNS).
*
Disable Disables Telnet.
Enable Enables Telnet.
Disable Disables Update Address Book.
*
Enable Enables Update Address Book.
Disable Disables HTTP-SSL/TLS.
*
Enable Enables HTTP-SSL/TLS.
Sets the IP address for Filter n.
Sets the address mask for Filter n.
*
Off Disables the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
Disables IEEE 802.1x.
Using the Operator Panel Menus and Keypad 316