3. Click the Run menu option. The Run dialog box appears:
4. Type A:\SETUP (or B:\SETUP as appropriate), then press
Enter or click OK. The ELP Link III introduction
appears.
5. Press C to continue.
6. To accept the default location for where the software
should be installed, press C to continue. Otherwise, enter
a new directory name and then press C.
7. The Link III software communicates with the projector
using the computer's serial communication (COM) port.
Specify which COM port to use, then press C to continue.
(Most likely, your computer is using COM 1.)
8. A summary screen appears stating how much free hard
disk space is required to run the software and how much is
available. If sufficient disk space is available, press C.
Otherwise, press X (exit) to free up some disk space; then
restart the installation program from step 1.
9. You see a prompt to create the installation directory you
specified in step 6. Press Y (yes).
62
Using the ELP Link III Software