Table of Contents
Advertisement
2. Connect the main cable. The main cable connects the
mouse cable (needed to use the remote control as a
mouse) and serial cable (needed to use the ELP Link III
software) to the projector.
a. Connect the small end of the main cable to the
b. Connect the MAC mouse cable (9-pin) to the
c. Disconnect the mouse from the computer port, and
d. If you are planning to use the ELP Link III software,
e. Tighten the screws on all connectors to make sure they
22
Installation
MAC serial
cable
MAC mouse cable
projector's Mouse/Com 1 port. The Mouse/Com 2
port is used when connecting a second computer.
MOUSE terminal on the large end of the main cable.
connect the MAC mouse cable (4-pin) to this port.
connect either end of a MAC serial cable to the MAC
SERIAL terminal on the large end of the main cable.
Connect the other end of the MAC serial cable to the
Printer port or Modem port on the back of your
PowerBook.
are fastened securely.
Main cable
Advertisement
Table of Contents
