Table of Contents
Advertisement
2. Connect the main cable. The main cable connects the
mouse cable (needed to use the remote control as a
mouse) and serial cable (needed to use the ELP Link III
software) from your Macintosh to the projector.
a. Connect the small end of the main cable to the
b. Connect the MAC mouse cable (9-pin) to the mouse
c. Disconnect the mouse cable from the Mouse port of
d. If you are planning to use the ELP Link III software,
18
Installation
MAC serial
cable
MAC mouse cable
projector's Mouse/Com 1 port. The Mouse/Com 2
port is used when you are connecting a second
computer.
terminal on the other end of the main cable.
the Macintosh and connect the mouse connector of
the MAC mouse cable to it.
connect either end of a MAC serial cable to the MAC
serial terminal at the large end of the main cable.
Connect the other end of the MAC serial cable to the
printer port or modem port on the back of your
Macintosh.
Main cable
Advertisement
Table of Contents
