Connecting Multiple Pcs To An Ethernet Lan - Planet VC-202 User Manual

5. LNK LED will from blinking to illuminate.
6. Connect Ethernet port to Ethernet device via regular Cat.
5 cable.
Figure 3-4: Connecting Standalone IP device

3.3.2 Connecting Multiple PCs to an Ethernet LAN

Refer to the following procedures to setup the VC-202 to an
Ethernet LAN.
1. Set the VC-202 to be CO mode or CPE mode from the
DIP switch at the rear panel.
2. Power on the VC-202 by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line / coaxial cable from another VDSL de-
vice to VDSL BNC port of the VC-202.
5. LNK LED will illuminate.
6. Connect Ethernet port to Ethernet Switch (or Broadband
Router) via regular Cat. 5 cable.
24