Table of Contents
Advertisement
● Air flow around the unit and through the vents in the side
of the case is not restricted (company recommend that
you provide a minimum of 25mm inch clearance)
To prolong the operational life of your units:
● Do not place objects on top of any unit or stack
3.2 Connecting VC-201
3.2.1 Connecting Standalone PC
Refer to the following procedures to setup the VC-201 to a
standalone PC.
1. Set the VC-201 to be CO mode or CPE mode from the
DIP switch at the rear panel.
2. Power on the VC-201 by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL
port of the VC-201.
5. LNK LED will from blinking to illuminate.
6. Connect telephone to the PHONE port.
7. Connect Ethernet port to PC Network Interface Card (NIC)
via regular Cat. 5 cable.
21
Advertisement
Table of Contents
