Getting Started; Connecting The Power And The Host Pc - Planet IECC-210T User Manual

6. Getting Started

This chapter provides a basic overview of how to configure and operate your
IECC-210 series.

6.1 Connecting the Power and the Host PC

Step 1: Connect both the TP IN port of the IECC-210T and RJ45 Ethernet
port of Host PC.
Ensure that the network settings on the Host PC have been correctly
configured and are functioning normally. Ensure that the Windows
firewall and any anti-virus firewall is properly configured to allow
incoming connections; if not, temporarily disable these functions.
Attaching an ESC (EtherCAT Slave Controller) directly to an
office network will result in network flooding, since the ESC will
reflect any frame – especially broadcast frames – back into the
network (broadcast storm).
Step 2: Apply power to the IECS-210T
Connect the Host
device to the IN Port on
IECC-210T
PC
12
V+
V+
V+
Connect the V+ pin to positive
terminal on a 9-48V DC power
supply, and connect the V- pin to
the negative terminal.
9-48V
DC
+