Optipoint 500 Analog Adapters - Siemens optiPoint 500 Service Manual

Option Adapters and Ports

optiPoint 500 Analog Adapters

5.3 optiPoint 500 Analog Adapters
This type of adapter is used for connecting an analog terminal (e.g. telephone, group 3 fax, mo-
dem, cordless telephone) to the system telephone.
A local power supply unit is required when using an analog adapter.
>
Only DTMF terminals can be connected to an analog adapter
(no dial pulsing).
Functions
The connected analog equipment can use this interface to send and receive calls indepen-
●
dently of the voice call status of the basic device, provided that a B channel is available.
During adapter initialization, country-specific information (such as impedance and flash
●
signal duration) is loaded.
You can connect an external ringer (secondary bell for the telephone) via TA a/b.
●
The AC bell, which can be connected instead of an analog terminal, is treated like a "phys-
ical device" (source) and receives signals from the system.
Administration is in MULAP form.
5-8
MW6/6
Pin 1 Pin 2
NC NC
6 5 4 3 2 1
Nur für den internen Gebrauch
Pin 3 Pin 4 Pin 5
TIP + RING NC
RJ11
P31003-E8400-A100-3-7620
Pin 6
NC
Service Manual