Pre-Installation Checklist; Installing The 4610Sw/4621Sw Ip Telephone - Avaya one-X Quick Edition User Manual

Pre-installation Checklist

You require the following items to install your 4610SW/4621SW IP telephone. These items are
shipped with the 4610SW/4621SW IP telephone. Verify that the 4610SW/4621SW IP telephone
package includes the following items:
one telephone set (includes a telephone stand),
●
one Category 5 (Cat5) modular line cord, for connecting the telephone to an Ethernet LAN
●
or a PC, and
the Avaya one-X Quick Edition Telephone Quick Installation Guide.
●

Installing the 4610SW/4621SW IP Telephone

See Figure 3 and
telephone. Figure 5
IP telephone. Choose the assembly that is best for your situation.
Power is typically supplied to the telephone by connecting the Cat5 modular line cord to a
802.3af PoE-enabled Ethernet LAN. Option A, shown in
wall-jack connection, but you could connect the Cat5 modular line cord directly to a
PoE-enabled Ethernet switch. If your Ethernet network does not provide 802.3af-compliant
inline power, you must supply a PoE inline power supply (see Option B shown in
Figure 6).
!
CAUTION:
The last step in installing the 4610SW/4621SW IP telephone must be applying
CAUTION:
power.
You may optionally connect the telephone between a computer and the Ethernet LAN—the
telephone and the computer share the connection. In this case, you must supply a second Cat5
(or better) modular line cord to connect the telephone to the computer. For more information,
see To share the telephone LAN connection with a computer on page
Avaya one-X Quick Edition Release 1.0.0 Telephone User Guide
Figure 4 for two possible ways to assemble and connect a 4621SW IP
and Figure 6 show two possible ways to assemble and connect a 4610SW
Pre-installation Checklist
Figure 3 and Figure 5, shows a
31.
Figure 4 and
25
March 2006