Safety And Homologation Statements; Safety Statements; Lithium Batteries; Lightning Protection/Hazard Symbols - Avaya IP Office 3.0 Installation Manual

Safety and Homologation Statements

Safety Statements

CE Mark
•
The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC
(R&TTE), 89/336/EEC (EMC), and 72/23EEC (LVD) Directives
Declaration of Conformity
• The Declaration of Conformity (DoC) for the IP Office - Small Office Edition products is contained
with in the CD accompanying the products.
• This warning symbol is found on the base of the Avaya IP Office - Small Office Edition.
Refer to page 36 for information concerning which Trunk Interface module variants are fitted in
which country.
WARNING The Avaya IP Office - Small Office Edition units are intended to be installed by 'Service
Personnel' and it is the responsibility of the Service Personnel to ensure that all subsidiary
interconnected equipment is wired correctly and also meet the safety requirements of IEC60950
or UL60950 where applicable.

Lithium Batteries

A lithium battery is fitted to the real time clock on the Avaya IP Office - Small Office Edition mother
boards.
• WARNING
The Lithium battery must only be replaced by Avaya personnel or authorized
representatives. There is a danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.

Lightning Protection/Hazard Symbols

The building's lightning protectors must be verified as follow:
1. Check the lightning protectors, at the trunk cable entry point to the building housing the Avaya IP
Office - Small Office Edition, paying special attention to the lightning protection grounding. Report
any problems, in writing, to the telephone company.
2. Equipment that is designed to be connected using internal wiring is typically not lightning
protected. Hence, Avaya IP Office - Small Office Edition extension cabling must not leave the
building.
The shock hazard symbol is intended to alert personnel to electrical hazard or equipment
damage. The following precautions must also be observed when installing telephone equipment:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
3. Never Touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
4. Always use caution when working with telephone lines.
Small Office Edition Installation Manual
IP Office 3.0 40DHB0002UKED Issue 3 (4th February 2005)
Page 35