Connecting & Checking Two-Wire Telephones; Power Fail Telephones And Sockets - Avaya IP Office 3.0 Installation Manual

Small Office Install
Connecting & Checking Two-Wire Telephones
All two-wire devices (POTS) should be tested according to the manufacturer's instructions before
connection to the Avaya IP Office - Small Office Edition system. Connect the two-wire device and make
a test call.

Power Fail Telephones and Sockets

The power fail sockets (see Power Fail) must be tested.
To test a power fail socket
1. Locate the socket and check that it is clearly labeled as a power fail socket.
2. Connect a telephone to the socket.
3. With power to the Avaya IP Office - Small Office Edition system switched on, make a test call.
4. Switch the power to the Avaya IP Office - Small Office Edition system off and again make a test
call.
5. Switch the power to the Avaya IP Office - Small Office Edition system back on again.
6. Repeat the test for any other power fail sockets.
•
Note
Where E911 statuary requirements for discrete location identification of a power fail
phone are required on the transmitted CLI, ensure that the relevant installation
programming is completed.
Small Office Edition Installation Manual
IP Office 3.0 40DHB0002UKED Issue 3 (4th February 2005)
Page 30