Memory
To remove the memory, perform the following steps:
1. Remove the main hatch, as described above.
2. Remove the memory modules (marked by the red square).
Mini-PCI
To remove the mini-PCI card:
1. Remove the main hatch, as described above.
2. Disconnect the two antenna cable (black=main, grey=aux), indicated by the little
red square in Fig. 4.
3. Remove the two screws (2xA) from the card (as shown in Fig. 4).
4. Lift out the mini-PCI card.
Heat Sink
To remove the heat sink, perform the following steps:
1. Remove the main hatch, as described above.
2. Remove the wireless antenna guiding tape.
3. Remove the 4 CPU screws (4xB) and 2 chipsets screws (2xC) from the heatsink
(as shown in Fig. 4).
4. Slide the heatsink upwards and to the left, then lift it out.
Fig. 4
Removing the memory module(s), mini-PCI and heatsink.
6