Battery And Ac Adapter; Removing The Hard Disk Drive - Packard Bell EasyNote SW Series Disassembly Manual

Battery and AC Adapter

To remove the battery, do as follows:
1. Turn off the computer.
2. Disconnect the AC adapter.
3. Remove the battery.
Hard Disk Drive (& Bluetooth – optional)
To remove the hard disk drive, perform the following steps:
1. Remove two screws (2xA) from the HDD cover (as shown in Fig. 1).
2. Remove the HDD cover.
3. Remove two screws (2xB).
4. Slide the HDD to the left, away from its connector. Then lift it out.
5. Remove the Bluetooth module (optional). Its location is marked by the red
square.
Fig. 1
The bottom base.
Fig. 2

Removing the hard disk drive.

4