Keyboard - Packard Bell EasyNote ME Disassembly Manual

1010101010
Note: Pay close attention to the DC jack cable after replacing the main board for example. You should tape the
cable firmly to the bottom cover and guide it underneath the optical disk drive connector on the main board.
Otherwise, the optical disk drive will not fit properly when inserting it.

Keyboard

To remove the keyboard, first remove the battery (see Battery) and then perform the following steps:
1. Turn the notebook over so the top is facing up and open the LCD completely.
2. Release the cover by prying it up on the left side of the notebook.
3. Tilt the cover from the left to the right and lift it out.
4. Remove the 4 screws securing the keyboard.
5. Tilt the keyboard gently forward (see
Fig. 15 Removing keyboard cover.
Fig. 16 Location of keyboard screws.
Fig.
Packard Bell EasyNote ME Disassembly Manual
16).
10