Trane TRACER SUMMIT BMTX-SVU01B-EN Daily Operations page 81

BMTX-SVU01B-EN
Note:
Click on the More control button at the bottom of the dialog box
to display the Priority Arrays box. To perform an override, your
default control priority level must be higher than priority level
listed in the box. If not, refer to "Using the Advanced Systems
Override" on page 72.
2. Verify the control knob is in the Change to position.
3. Click the toggle switch to set it to the On state, or click the toggle
switch to set it to the Off state. With either selection, the On or Off
label will then appear in bold.
Note:
The toggle switch labels are defined in the Binary Output
editor and can be assigned names other than On and Off.
4. Click the Apply button to apply the override and view the results, or
click OK to apply the changes and close the dialog box.
To return control back to the BAS, see "Releasing Control Back to the Sys-
tem" on page 71.
Using the Simplified Override Dialog Box
69