Remote Operation; Battery Replacement - Dimplex ELECTRALOG DF203A Owner's Manual

Operation
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call technical
support at 1-888-346-7539.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. this odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.

Remote Operation

the fireplace is supplied with an
integrated on/off
!
NOTE: Ensure that the
fireplace 3 position switch is set
to the remote control setting. to
operate, push the on button to
turn fireplace on, push the oFF
button to turn the fireplace
Remote Control Initialization/
Reprogram
In the event that your remote
control ceases to operate your
fireplace, follow these steps
to reinitialize the hand held
transmitter and the remote control
receiver in the fireplace:
1. Place the
Switch (Figure 8A) in the oFF
("o") position.
2. Wait a minimum of 5 seconds
12
remote control.
off.
Main on/oFF
and then place the Main on/
OFF Switch in the remote
Control position.
3. Within 10 seconds of
changing the switch position,
press the on button located
on the remote control
transmitter (Figure 9). this
will synchronize the remote
control transmitter and the
fireplace receiver.
! NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.

Battery Replacement

to replace the battery:
1. slide battery cover open on
Figure 9
ON
Button
OFF
Button
Battery
Battery Cover
www.dimplex.com