Operation - Dimplex ELECTRALOG DF203A Owner's Manual

Operation

to access the controls, swing
down the front cover panel
located on the lower front of the
fireplace (refer to diagram below).
(Figure 8)
A. Main ON/OFF Switch
the switch has two on positions
marked with
The "Manual" position is for
manual operation. In this position
the built-in remote control is by-
passed.
The position is for operating
the unit with the provided remote
control.
When in position the unit is
operated with the ON and OFF
buttons of the remote control.
When the switch is in the center
position the unit is off.
B. Heater ON/OFF Switch
the Heater on/oFF switch
supplies power to the heater
fan and the heater element.
When the switch is in the on
Figure 8
and "Manual".
position the heater operates if the
thermostat calls for heat.
C. Heater Thermostat Control
To adjust the temperature to
your individual requirements,
turn the thermostat control
clockwise all the way to turn
on the heater. When the room
reaches the desired temperature,
turn the thermostat knob counter
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
Resetting The
Temperature Cutoff
Switch
should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
main on/oFF switch to oFF
and waiting 5 minutes before
switching the unit back on.
11