Advertisement
Operation
Figure 5
A
WARNING: This unit must be
properly installed before it is
used.
There are three different control op-
tions available for the unit: manual
(under the media plate), tethered
controller (must be connected to
the unit) and a remote control.
The CDFI1000P unit has two
separate internal modules that are
controlled by the settings entered
on the left side (primary). Finer
adjustment can be done using the
controls on the right module to
have both modules operating at the
same level (secondary).
!
NOTE: When the unit is used
in an environment where back-
ground noise is very low, it may be
possible to hear a sound which is
related to the operation of the flame
effect. This is normal and should
not be a cause for concern.
!
NOTE: Always ensure that the
appliance is fixed to the framing in
a level position.
B
C
E
D
Figure 6
Remote Control
!
NOTE: The icons with 1 dot indicate
controls for the primary and 2 dots
indicate controls for the secondary. The
secondary controls are not applicable for
the CDFI500P.
Controls
A. On/Off Switch
Supplies power to the unit.
NOTE: When the unit is first
!
turned on the lights will come on
and mist will appear 45 seconds
later.
F
Tethered
Controller
13
Advertisement
