Table of Contents
Advertisement
VIVOTEK
PTZ > PTZ settings
This section explains how to control the Network Camera's Pan/Tilt/Zoom operation�
The camera comes with built-in PTZ mechanisms�
1
3
Preset positions and patrol settings
In the PTZ settings page, you can select preset positions for the camera to patrol� A total of 128 preset
positions can be configured.
Please follow the steps below to configure preset positions and arrange them in a pan/tilt/zoom tour:
1� Adjust the shooting area to the desired position using the keypad on the upper right side of the
window� The default Home position refers to the center position defaulted in the factory� You might as
well select another area of interest as the "Home" position. You should also select the speeds for the
actions that occur during the patrol; i�e�, pan, tilt, zoom, focus, and the auto pan/patrol�
2� Enter a name for a new preset position, which can contain up to forty characters� Click Add to enable
the settings� The preset positions will be listed on the User preset locations� (To add positions you
wish, please repeat steps 1~2.)
3� Select the preset positions and click on the Save button at the bottom of the screen�
4� Click on the move button (>>)
5� You may select some or all of the imported positions as the stop points during the tour�
6� Enter a preferred dwell time before moving to the next position�
7� Click on the Save button to preserve your configuration.
To remove a preset position from the list, select it and click Remove�
You can re-arrange the patrol order of the positions on the list using the
82 - User's Manual
Advanced Mode
2
5
4
to move positions to the Patrol locations window�
1
6
7
buttons�
Advertisement
Table of Contents
