Table of Contents
Advertisement
Status LED
Item LED status
1
Steady red
Red LED off
2
Steady red & Green blinking every 1 sec�
Steady red & Green LED off
3
Steady red & Green LED blilnking every 2 sec�
4
Red blinking every 0�15 sec� & Green blinking
every 1 sec�
5
Red blinking every 0�15 sec� & Green blinking
every 0�15 sec�
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button for a while to restore. Note that almost all
previous configuration changes will be restored to factory default.
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC 32GB and other preceding standard SD cards�
DI/DO Diagram
Please refer to the following illustration
for the connection method�
Description
Power on and system booting
Power off
Network normal (heartbeat)
Network failed
Audio mute (heartbeat)
Upgrading firmware
Restoring default
12V
PIN 1
Power+12V
PIN 2
Digital output
+12V
PIN 3
Digital input
PIN 4
Ground
VIVOTEK
User's Manual - 7
Advertisement
Table of Contents
