Bouncing The Desired Part Of A Song - Fostex MR-8MKII Owner's Manual

MR-8mkII Owner's Manual (Track bouncing)

Bouncing the desired part of a song

Typically, bouncing is executed from the beginning to the end of a song, as shown in Figure 1
below. However, you can bounce only the desired part by using the track bouncing and punch
in/out functions together. The following assumes that the song you are going to execute track
bouncing is loaded and you finished rehearsal of track bouncing.
The following procedure shows the example of bouncing the desired part of a song in the "Bounce
1-6 > 7/8" mode (<Caution!>: In the "1-8 > NEW SONG" mode, you cannot bounce the desired part of a
song by using the track bouncing and auto punch in/out functions together).
Typical bouncing (Fig. 1)
ABS ZERO
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
1) Set the punch-in and punch-out points (see page
56).
By pressing the [PLAY] key while holding down
the [STOP] key, you can play back the part
between the punch-in and punch-out points
(see page 46).
2) Locate the recorder to a position before the
punch-in point.
3) Press the [1-4>5/6, 1-6>7/8] key to set the bounce
mode to "1-6>7/8".
When setting the bounce mode to "1-6>7/8",
tracks 7/8 automatically enter the input
monitor mode and "
home screen.
Lighting
4) Press the [AUTO PUNCH] key to activate the auto
punch mode.
When the auto punch mode is active,
" " lights on the home screen.
REC END
" lights on the
Flashing
Lighting
Bouncing the desired part (Fig. 2)
Punch in point
(=LOCATE A point)
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
5) Press the [RECORD] key while holding down the
[PLAY] key.
The "
starts playback. It automatically starts
recording (bouncing) when it reaches the
punch-in point.
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
The recorder stops recording (bouncing) at the
punch-out point and returns to playback, while
Lighting
the auto punch mode exits and "
the screen turns off.
<Note>:
above, you cannot monitor the sound. You
can monitor the sound (bounced sound)
only during recording between punch-in and
punch-out points.
6) Press the [STOP] key to stop the recorder.
Check the result by playing back the bounced
tracks, as described earlier.
<Note>:
sult, press the [UNDO/REDO] key to redo the
operation.
74
Punch out point
(=LOCATE B point)
" icon is shown and the recorder
Punch-in point
(=LOCATE A point) (=LOCATE B point)
Recording
Playback
(track bouncing)
(Input monitor)
During playback in the operation
If you are not satisfied with the re-
Punch-out point
Playback
" in