Fostex MR-8MKII Owner's Manual page 127

<Note>: Depending on a CD-R/RW drive, the
following screen may pop up when entering
the USB HOST menu selection screen. While
this pop-up screen is shown, the internal op-
eration between the MR-8mkII and the CD-R/
RW drive is being executed. The pop-up screen
will disappear after about ten seconds. After
the screen disappears, you can select the USB
HOST menu.
<Note>:
During operation, if "Not Mounted"
is shown at the bottom of the display as be-
low, the MR-8mkII is not correctly connected
to the CD-R/RW drive.
In such a case, confirm that a disc is set to the
CD-R/RW drive, then unplug and replug the
USB cable while the MR-8mkII is not access-
ing the CompactFlash
drive.
4) Use the JOG dial to select "CD Burn>" and press
the [MENU/ENTER] key.
The display changes to show the screen for
selecting a desired stereo WAV file from the
"2 MIX" folder of the currently loaded song.
The following (bottom) shows a screen example
where only one stereo WAV file exists in the
"2 MIX" folder.
<Note>: The following shows a screen ex-
ample where multiple stereo WAV files ex-
ist in the "2 MIX" folder of the currently
loaded song.
TM card or the CD-R/RW
MR-8mkII Owner's Manual (Burning an audio CD)
<Note>: If you attempt to execute "CD Burn"
when a song of the LP mode is loaded, the
display shows the warning message as below
and returns to the USB HOST menu selection
screen.
If you select a stereo WAV file recorded in a
song of the LP mode, you cannot create an
audio CD. In such a case, exit the MENU mode
and reselect a song of the Normal mode, then
execute the procedure above from the begin-
ning.
5) Use the JOG dial to select the desired WAV file
and press the [MENU/ENTER] key.
The MR-8mkII starts writing to the CD-R/RW
disc, while the display changes to show the
following screen. While the MR-8mkII is
writing to the CD-R/RW disc, "Writing..." is
shown and the "ACC" flashes on the screen.
The access indicator on the CD-R/RW drive will
also flash. In such a condition, do not turn off
the power or press the eject key of the drive.
Also note that all of the MR-8mkII keys are dis-
abled while the MR-8mkII is writing to the disc.
When the MR-8mkII finishes writing to the disc,
it stops CD-R/RW disc access and the display
changes to show the following screen.
<Note>:
writing song data to a disc, the following
message may appear.
127
If there is a writing error while