Table of Contents
Advertisement
Setting the System Clock
sents minutes and ss represents seconds. You must use two digits to specify the minutes and two digits to
specify the seconds. The following command will set the switch's system time to 10:45:00 a.m:
-> system time 10:45:00
The following command will set the switch's system time to 3:14:00 p.m:
-> system time 15:41:00
Daylight Savings Time Configuration
The switch can be set to change the system clock automatically to adjust for Daylight Savings Time (DST)
depending on the timezone selected. Refer to the table on
settings. Enable DST on your switch by using the following command:
-> system daylight-savings-time
Note. By default, Daylight Savings Time is disabled.
page 2-18
page 2-19
OmniSwitch AOS Release 7 Switch Management Guide
Managing System Files
to determine daylight savings time
March 2011
Advertisement
Table of Contents
