Configuring the Console Port
Configuring the Console Port
The console port default settings are listed in the Hardware Users Guide. If you wish to modify the
default serial connection settings (i.e., baud rate, parity, data bits, stop bits, and mode), use the modify
boot parameters command as shown:
-> modify boot parameters
Boot > boot serialbaudrate 19200
Boot > boot serialparity even
Boot > boot serialwordsize 7
Boot > boot serialstopbits 2
Boot > boot serialmode modemControlOn
Boot > show
Serial (console) baud: 19200
Serial (console) parity: even
Serial (console) wordsize: 7
Serial (console) stopbits: 2
Serial (console) mode: modemControlOn
Boot > commit system
Boot > commit boot
Boot > exit
•
Output to the terminal may become illegible due to incompatible serial connection settings between the
switch and the terminal emulation software.
•
If you use the commit system command only, changes will not be saved to the switch's non-volatile
memory and will be lost if the switch is rebooted.
page 1-6
OmniSwitch AOS Release 7 Switch Management Guide
Logging Into the Switch
March 2011