Connecting Other Components - Onkyo BR-925 Instruction Manual

Connections—Continued

Connecting Other Components

The following diagram shows how to connect other components (i.e., a cassette deck, an MD recorder, a CD recorder)
and an Onkyo RI Dock (Remote Interactive Dock). If Audyssey EQ™ is active, you cannot perform recording (except
for timer recording) to an external component. Deactivate Audyssey EQ™ when you want to record to an external
component (see page 26).
Connecting an MD recorder or cassette deck
Connect the CD/HDD receiver's MD/TAPE OUT jacks to the INPUT (REC) jacks of the MD recorder or cassette deck.
Connect the CD/HDD receiver's MD/TAPE IN jacks to the OUTPUT (PLAY) jacks of the MD recorder or cassette deck.
Connecting a CD recorder or an Onkyo RI Dock
Connect the CD/HDD receiver's DOCK/CDR OUT jacks to the AUDIO INPUT jacks of the CD recorder or Onkyo RI
Dock.
Connect the CD/HDD receiver's DOCK/CDR IN jacks to the AUDIO OUTPUT jacks of the CD recorder or Onkyo RI
Dock.
Connecting Onkyo Components
First connect each Onkyo component to the CD/HDD receiver with an analog audio cable (RCA) as described above.
Next, make the necessary
to the corresponding component name (see page 45).
MD recorder
Cassette deck
CD recorder
Onkyo RI Dock
What can you do with
• Connecting an Onkyo
ponent with the CD/HDD receiver's remote controller.
• When playback is started on the
the input source.
• When you start playback on the component connected via
matically turn on. Similarly, when the CD/HDD receiver is set to Standby, all components connected via
go on Standby.
Notes:
• No cable is included with the
• Use jacks for a combined use with
• Some -capable components have two
connecting additional -capable components.
connections with an cable (see illustration below). Finally, change the Input Display
R L
Analog audio
cables (RCA)
cable sup-
plied with the
Onkyo RI Dock
R L
cable supplied with other Onkyo components
?
to the CD/HDD receiver via
-capable component
connected via
component
CD/HDD receiver
. Use
-capable components.
jacks. They're both the same, so you can use either one. The extra jack is for
CD/HDD receiver's rear panel
cable allows you to control the
, the CD/HDD receiver will automatically select it as
, if the CD/HDD receiver is on Standby, it will auto-
cables supplied with other Onkyo components.
: Signal flow
com-
will also
19