Connecting An Ri Dock; Connecting The Power Cords Of Other Components (North American Model Only) - Onkyo TX-SR876 User Manual

Connecting the AV Receiver—Continued

Connecting an RI Dock

Not all iPod models output video. For information
about which iPod models are supported by the RI
Dock, see the RI Dock's instruction manual.
■ If Your iPod Supports Video:
Connect your RI Dock's audio output jacks to the
AV receiver's AUX 1 IN L/R jacks, and connect its
video output jack to the AV receiver's AUX 1 IN V
jack.
(Onkyo DS-A2X hookup shown below.)
V
IN
L
R
■ If you have an Onkyo DS-A1 RI Dock
• Connect its video output jack to the AV receiver's AUX 1 jack.
Notes:
• Connect the RI Dock to the AV receiver with an u cable (see page 50).
• Set the RI Dock's RI MODE switch to "HDD" or "HDD/DOCK".
• Set the AV receiver's Input Display to "DOCK" (see page 63).
• By using the [CD] (TX-NR906) or [DOCK] (TX-SR876) REMOTE MODE button on the remote controller of
the AV receiver to change the remote mode to "DOCK", you can operate your iPod in the RI Dock (see page 20).
If you cannot operate it, you will need to enter the appropriate remote control code (see page 137).
• See the RI Dock's instruction manual for more information.

Connecting the Power Cords of Other Components (North American model only)

The AV receiver has AC outlet on its rear panel that can be used to
connect the power cords of other components that you intend to use
with the AV receiver. These components can then be left turned on so
that they turn on and off as and when the AV receiver is set to On or
Standby.
Caution:
• Make sure that the total capacity of the components that you con-
nect to the AC OUTLET does not exceed the stated capacity.
Notes:
• When the "HDMI Control" setting is set to "Enable" (page 118),
the AC outlet are on all the time regardless of whether the AV
receiver is set to On or Standby, or Ready mode in this case, so any
components connected to them cannot be turned on or off automat-
ically.
• Onkyo components connected via u should be connected
directly to a wall outlet, not an AC OUTLET on the AV receiver.
■ If Your iPod Doesn't Support Video:
Connect your RI Dock's audio output jacks to the
AV receiver's AUX 1 IN L/R jacks.
(Onkyo DS-A2X hookup shown below.)
IN
L
R
North American model
AC OUTLET
AC 120V 60Hz
SWITCHED
120W 1A MAX.
49